Skip to content

Fast Pipe Lining, Inc.

  • header-icon-no-dig


Cure-In-Place Pipe liners can be installed using several methods with three types of resin curing systems. CIPP liners can utilize steam, hot water, ultra-violet or ambient resin curing systems. FAST Pipe Lining does not provide or recommend the use ultra-violet or ambient curing resin systems. FAST Pipe Lining provides CIPP installation contractors with all types of liners to suit specific installation applications. Installation contractors play a critical role as they control the installation & cure of the CIPP liner.

Inversion Liners - The most commonly used CIPP liners are for installation by the inversion method. Inversion is the process where the liner is turned inside-out during the installation using a column of water or pressurized air; the liner walks itself through the host pipe. Inversion results with the exterior liner coating becoming the new interior pipe wall surface with the resin saturated felt pressed against the host pipe wall. The inversion process can be done using air pressure (a shooter or air inverter) or a water column (inversion water column). Water inversion was the original installation method used for over 25 years before air inversion method was developed.

Hot Water Inversion Method is the original installation method. Cold water (not hot) is used to invert the Cured-In-Place Pipe liner into position within the host pipe. Before the remainder of the liner enters the inversion column, a hold back rope and hot water discharge hose(s) are attached to the end. The hold back rope allows technicians to control the water column head pressure and to prevent the uncontrolled runaway of the liner. The discharge hoses are attached to be towed into place at the far end of the CIPP liner where heated water will be discharged from the hot water boiler. Inversion by water allows for the CIPP liner to invert slowly through the pipe while being pressed tightly against the pipe wall. Water in low spots in front of the liner is displaced as the liner travels through the pipe. When the liner is installed, water is pumped from the inversion column into a high output boiler truck then forced through the discharge hose(s) to the end of the liner. This forms a continuous water flow loop, circulating water from one end of the liner to the other. Water temperature is raised until the appropriate temperature is attained and held at temperature until the resin exotherms or cures. After the cure has completed, cold water is then circulated to gradually cool the liner to prevent shrinkage. When the liner is cool, the ends are cutoff to reveal a "new pipe within a pipe."

Fast Pipe Lining provides ready to install CIPP liners using several different catalyzed resin systems for use with steam or hot water curing systems, all which conform to ASTM Standards.

Test Samples
As part of the wet-out process, sample material from CIPP liners is used to prepare flat plate test samples. Samples are compressed between two pieces of metal to the specified thickness then wrapped in polyurethane. Test samples are shipped with the related CIPP liner to the installation site where the sample is cured as part of the liner installation process. To cure flat plate samples, samples can be submersed in the inversion water column or placed with the CIPP liner for steam curing. For hoop test samples, Fast Pipe Liner can ship pre-cut plastic pipe sections for sample making at the time of installation, a time saving process for installation crews.

Hot Water Inversion Method
Contractor Project 6

NOTE: All pictures, videos, designs and specifications are subject to change without notice.

Translate »